Chopping Wood: A Beginner’s Guide

Firewood is sold in measurements called cords and half-cords. A cord of stacked firewood measures 8 feet long by 4 feet high by 4 feet deep, or 128 cubic feet. A half-cord is half as long (so 4 feet × 4 feet × 4 feet), or 64 cubic feet. Currently in Connecticut the going rate for a cord is between $200 and $300, depending on the type of wood.

tools for chopping wood leaning against a stack of wood

If you have a fireplace or stove and some trees on your property that need taking down, then you can kill two birds with one stone by chopping your own firewood. Different woods burn differently. I burn a lot of maple because that’s what’s on our property, and it burns well once it’s been properly seasoned. I don’t recommend burning resinous woods like pine or cedar as the sap or oil sparks and pops when heated; it’s like throwing fireworks into your fireplace.

Know Your Tools

If you’re going to do your own wood chopping, it’s good to know the differences between various tools before you shop. I once had to explain to a clerk at Home Depot — a grown man — the distinction between an ax and a hatchet. Don’t be that guy.

an-ax-and-a-wood-splitter

  • An ax is for cutting down trees. It has a slim head and a long blade edge.
  • A wood splitter has a thicker wedge-shaped head and a shorter edge. It’s made to split logs.
  • A hatchet is a small one-handed ax, useful for cutting down saplings or pruning branches at the trunk.
  • A sledgehammer and a wedge are for splitting logs.

Some mauls have a double-sided head with a blade on one end and a hammer on the other. I’ll discuss below how to use all these tools.

Felling Trees: Put The Princess To Bed

The biggest question when cutting down a tree is determining where it will fall. You want it to fall in a straight, uninterrupted path to the earth, without hurting anyone, any property, or becoming entangled in the branches of surrounding trees.

Don’t assume the weight of a falling tree will smash through the branches of other trees. If the tree cover is dense, it’s very likely the falling tree will become caught, creating a precarious situation of an untethered tree floating overhead like a guillotine, supported only by those branches.

Depending on how much land you have and the tree’s proximity to your neighbors’ property, you may want to consider hiring a tree service to take down tall trees.

While it can be expensive, a tree service will cut a tree top-to-bottom in pieces using a cherry picker or, if they can’t reach it with the picker, with lines and harnesses. That way you don’t have to worry about the tree falling on, say, your neighbor’s house.

Once you’ve decided you can safely take down a tree, the tool for the job is an ax. I don’t like using a chainsaw for the simple reason that they’re loud; when the tree starts to fall, it will make loud cracking noises, and that’s your signal to get away from it. You want to hear those noises, and you will if you use an ax.

To cut down the tree, begin chopping a wedge into its trunk facing the direction in which you want it to fall. In other words, imagine an arrow stemming from the exact center of the wedge pointing toward its intended trajectory. Once you start chopping, never walk in front of the wedge; if you have to move around to the opposite side, walk behind the tree.

Always keep a path open to back away (or even run) from the tree once it falls, and don’t allow yourself to be trapped against another tree or obstacle. While the tree should fall fairly straight, it may roll to the sides or act unpredictably.

Also, don’t stand behind the tree as it can kick fragments and debris when it topples. When you hear it start to crack and snap, that’s your cue to move away.

Splitting Logs

Now’s the time to use that chainsaw! You can cut the tree into logs (with a hand saw, if necessary). If you’ve used a service, ask them to do it for you.

If you’re planning to use the wood for a stove or fireplace, a good idea is to measure the space and cut the logs into convenient lengths that will fit. The standard size is between 16 and 18 inches long.

Seasoning The Logs (Or Not)

You can either split the wood right away or stack the logs and let them season for a bit. If you’re using a mechanical hydraulic splitter it doesn’t matter, but if you’re going to split the wood by hand, then it depends on what kind of wood you have.

Some wood splits easier when green and becomes tougher as it dries; on the other hand, I’ve found maple is easier to split after it has dehydrated for a year. You can search around or read some forums on when to split various species.

If you’re planning to let the logs season, the important thing is to get them off the ground either by stacking them on old shipping pallets or on logs you don’t plan to burn. Any wood touching the ground will become soggy and rotten, so if you’re sacrificing logs for a base layer, choose the knottiest, which are the hardest to split.

After about a year, you’ll notice the drying logs will fissure and crack. That’s when you know they’re ready to split.

the top of a log before being split for wood

Setting Up Your Splitting Workspace

Find a hard surface on which to split the logs, either an old stump or a bigger flat log or densely packed ground. Soft soil or grass will absorb much of the energy of your swing, making it harder to split the log. You literally want to put the log between your wood splitter and a hard place.

Stand the log on your base and line any large cracks so they’re parallel to the blade of your wood splitter. Knots (the areas where the tree’s branches connect to the trunk) are tough to cut through, so arrange these logs so your blade won’t strike any of the knots.

Splitting logs is a bit like baseball in that you’ll have to find exactly where to stand, how far back to swing, and so on. The lower your grip is on the handle, the greater the arc of your swing, and therefore the more power the impact of the splitter will have. Keep your eyes focused on where you want the blade to land, and hand-eye coordination should do the rest.

Choosing The Right Tool

wood split over a stump

You’ll want to use a wood splitter for the splitting rather than an ax. The wood splitter’s wedge-shaped head helps drive the pieces apart as it travels through the log.

For really fat stubborn logs that don’t split easily, try a wedge and sledgehammer. Stick the tip of the wedge into a crack in the log, then hammer it deeper to widen the crack. Don’t hammer it so much that you can’t remove the wedge. Work the wedge around the log as much as you can, then set it aside and attack the widened cracks with your maul.

As you split, you’ll develop a collection of small splinters and fragments of wood. Throw them into a bag or box and keep them dry—they make great kindling.

Chaining Logs

a chained up log before and after splitting

A fun trick is to loosely wrap the log in a chain and S-hook (called a shackle) before you begin.

This way the log will stay standing as you split it—you wont have to reset every piece. You can halve it, quarter it, and split it into as many pieces as you want.

Then you can carry the entire bundle to your woodpile, undo the S-hook, and unroll the pieces like a carpet onto your pile. You should use a sturdier chain than I have in the photos; I found mine in the garage, courtesy of the previous owners, and you can see the links are splitting from the pressure.

Stacking Wood

wood split and stacked

Stack the split logs in a pile for further seasoning before burning; at least another year is recommended. Again, any wood touching the ground will absorb moisture and become useless, so either sacrifice some logs as a base, or buy or make a stand.

The more air that circulates around the logs, the quicker they will dry. You can experiment with different patterns or methods, which is an art form in itself.

Put On A Flannel Shirt And Make Some Cocoa

Just as there are competing ways to stack firewood, there are four-and-twenty ways to build a fire in the grate.

I’m a fan of a crisscross Jenga style where I stack two logs perpendicular to the two logs below it and make a stack three or four levels deep with a column of air in the middle.

Then I stuff some newspapers and kindling into the bottom of the column and light that on fire. If it’s been seasoned right, the wood will catch with just one match.

There are few experiences in this world as satisfying as splitting wood on a cool autumn or winter day. Add a cup of hot chocolate to the scene, and maybe a little snow on the ground? That’s a great morning right there.

Author Jackson Kuhl lives in a restored 1899 Dutch colonial revival on an acre in Connecticut. All photos in the post are take by him.

Related Posts

Affiliate Policy (full policy): Posts may contain links to outside vendors that pay us a commission when you purchase from them, at no additional cost to you. Thank you in advance for supporting our site.


Author: Nifty Homestead Community Submission

This blog post was submitted by one of our community members (scroll up for their personal bio). We welcome guest posts from the community that fit with our writer guidelines. Click here to learn more about how to write for Nifty Homestead.

Comment
  1. Love the post. Pretty sure all of that wood I split as a kid was using an axe, since that wood splitter doesn’t look like it could get the entire head wedged into a log the way an axe could.

Leave a Reply

Your email address will not be published. Required fields are marked *